FD-6045-CE and FD-8645-CE
Fire Deck Installation and Operation Manual
PG
25
OF
32
M0042.13 JULY 2019
TROUBLESHOOTING GUIDE
PROBLEM
CAUSE/SOLUTION
Controller will not turn on
1.
Incoming power to oven turned OFF� Check circuit breaker for circuit
supplying the oven� Check that any wall switches external to the oven that
control oven power are turned on� Check that any interlocks external to the
oven are turned on�
2.
If Controller still does not turn on, please contact your local distributor for
assistance�
Radiant flame does not light
1.
Is gas turned on to the oven? Is gas shut-off valve turned all the way on?
2.
Debris in burner� Burner may require cleaning� Contact your local
distributor for assistance�
3.
Damaged igniter or gas valve� Contact your local distributor for assistance�
If the oven is being started for the first time:
Has all air been bled from the gas line?
Is the switch on the SV-2 valve in the “ON” position?
NOTE:
Valve is located beneath the oven at the rear, towards the side where
the radiant burner is located�
Flame cuts out
1.
Debris in burner�
2.
Oven is being run with the Night Heat Retention Door in place� Door must
be removed whenever the oven is turned on�
3.
Wind blowing into the oven, or other venting issue�
Underfloor IR burner is not running�
“Hearth Heat” light is OFF�
Hearth temperature is above the Hearth Set Point�
Hearth Temperature is above the
Hearth Set Point�
Underfloor IR burner did not fire when the floor temperature dropped below
the Hearth Set Point� Contact Wood Stone for assistance�
“Chec” display on Controller
Underfloor IR burner did not fire when the floor temperature dropped below
the Hearth Set Point� Contact your local distributor for assistance�
“Chec” display on Controller
See “Radiant flame does not light” above�
Содержание FIRE DECK 6045
Страница 31: ...PG 31 OF 32 M0042 13 JULY 2019 Blank page ...