Wood Stone FIRE DECK 6045, Инструкция по установке и эксплуатации

Страница: 20 / 32

FD-6045-CE and FD-8645-CE
Fire Deck Installation and Operation Manual
PG
20
OF 32
M0042.13 JULY 2019
DAILY OVEN OPERATION
TURNING OFF THE OVEN
Push the I/O button on the controller to turn the oven OFF.
Both burners will go out and the digital readout on the controller will go out�
ADJUSTING THE RADIANT (DOME) FLAME
The radiant flame(s) is (are) always ON when the oven is operating and can be adjusted to any flame intensity between its
highest and lowest setting by simply turn the Flame Height Control Knob� This burner is the primary heat source for the oven� The
Underfloor IR burner will act as an assist to maintain desired floor temperatures during periods of high food production�
ADJUSTING THE FLOOR HEARTH SET POINT
To adjust the oven's thermostatic Hearth Set Point temperature, simply press the arrow button corresponding to the direction in
which you would like the setting to go� If the thermostatic Hearth Set Point is raised above the actual hearth temperature, the
Underfloor IR burner should activate�
Note:
It is possible to program the floor’s thermostatic Hearth Set Point to temperatures from 37–427 °C (100–800 °F)� Once
proper temperatures for your application have been established, there should be little or no need to change the floor Hearth Set
Point�
DETAILED DAILY OVEN OPERATION
!
IMPORTANT: If at any time you feel that either or both of the burners are not operating properly,
turn the oven OFF and call for service. Before servicing, disconnect the electrical supply at the
breaker and turn OFF the gas supply at the appliance’s individual gas shut-off valve. In the event of
a power failure, no attempt should be made to operate the oven.
DAILY STARTUP
Press the I/O button to start the oven.
The radiant flame will ignite� The Underfloor Infrared (IR) burner will ignite if the actual floor temperature is below the set point
temperature to which the controller is adjusted�
Green light indicates the system is energized�
Green light
indicates the pilot flame for the radiant flame burner is lit�
Green light indicates that the pilot flame for the Underfloor IR burner is lit� This light will go OFF whenever the actual floor
temperature is above the thermostatic Hearth Set Point (see CONTROLLER section)�
SEE PAGE 18 FOR AN ILLUSTRATION OF THE OVEN CONTROLLER