Wood-mizer LT15SC M2 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 74 / 123

Setup & Operation
Loading, Turning, And Clamping Logs
3
3-13 doc020719 Setup & Operation
DANGER! Make sure all guards and covers are in place and
secured/closed before operating the sawmill. Failure to do so may
result in serious injury.
DANGER! Always be sure the blade is disengaged and all persons are
out of the path of the blade before starting the engine or motor. Failure
to do so will result in serious injury.
WARNING! Always wear eye, ear, respiration, safety clothing and foot
protection when operating the sawmill. Failure to do so may result in
serious injury.
3.6 Loading, Turning, And Clamping Logs
To Load Logs
1. Move the cutting head to the front end of the frame.
CAUTION! Before loading a log, be sure the cutting head is moved far
enough forward so the log does not hit it. Failure to do so may result in
machine damage.
2. Adjust the log clamps all the way down and move them toward the loading side of the sawmill frame.
CAUTION! Be sure the log clamps are all the way down before loading
a log onto the bed. Failure to do so may result in machine damage.
3. Raise the side supports on the sawmill bed to prevent the log from falling off the side of the bed.
4. Position the log at the foot of the ramps.
5. Use a cant hook to roll the log up the ramps and onto the sawmill bed. Position the log against the
side supports.
6. Remove the log ramps and set aside.
CAUTION! The saw head will hit the spring-loaded ramp stops when
adjusted for low cuts. Remove the loading ramps before sawing to
prevent damage to the saw head and/or blade guide arm.
If you did not purchase the optional loading ramps, use boards for ramps or use log loading
equipment to load the log on the sawmill bed.
To Turn Logs
1. Use a cant hook to spin the log against the side supports until it is turned the way you want it for the
first cut.
To Clamp Logs