Wood-mizer LT15SC M2 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 63 / 123

Setup & Operation
Setup & Operation doc020719 3-2
3
the motor body (fan guard). If the rotation direction is incorrect, invert
the phases in the phase inverter in the power socket (electric box).
Setting the phases in the phase inverter correctly will ensure correct
rotation directions of all sawmill motors.
WARNING! In case of a blade or drive belt brake, wait until all rotating
parts are completely stop. Failure to do so may result in serious injury.
DANGER! It is recommended that a 30mA Ground Fault Interrupter
(GFI) be used.
The LT15SC sawmills are only partially aligned at the factory. Some assemblies need to be aligned
by the user before first usage of the sawmill.
Assemblies aligned at the factory:

Blade drive belt tension;

Engine r.p.m. (DC only);

Blade wheels (in vertical and horizontal planes);

Blade guide arm alignment -
See Section 6.6
;

Blade guides -
See Section 6.7
;

Blade Height Scale -
See Section 6.13
;

Cam engaging the limit switch and/or stop bolt -
See page 3 - 8.
The following setup procedure should be performed whenever the sawmill is moved or reassembled.
If sawing problems occur and misalignment is suspected, see
6.1
for complete alignment
instructions.
1. Adjust the frame legs so the sawmill appears level. If sawmill is on soft ground, use shims under the
legs if necessary.
2. Run a string from the front bed rail to the rear bed rail near the operator’s side of the frame. Place
identical spacers between the string and the front and rear bed rails. Measure the distance between
the string and the other bed rails. Adjust the frame legs until all bed rails measure the same distance
from the string.
3. Loosen the auxiliary bed rail bolts and adjust the rail so it is the same distance from the string as the
main bed rails. Retighten the bolts.