Wood-mizer LT15SC M2 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 72 / 123

Setup & Operation
Tracking The Blade
3
3-11 doc020719 Setup & Operation
CAUTION! Release the blade tension when the resaw is not in use (for
example at the end of a shift). Tension the blade again before starting
the motor.
See Table 3-1. T
he recommended tension for different blades is shown below.
3.4 Tracking The Blade
1. Make sure the blade housing cover is closed and all persons are clear of the blade.
2. Start the motor for a moment until the blade positions itself on the wheels.
WARNING! Do not spin the blade wheels by hand. Spinning the blade
wheels by hand may result in serious injury.
3. Turn off the engine and check the position of the blade on the blade wheels.
See Figure 3-10. Position 1 1/4” wide blades so the gullet is 1/8" (3.0 mm) out from the edge of the
blade wheel (±1/32 [.75 mm]).
Blade Type Blade Dimensions Tension range
Width (mm) Height (mm) PSI Bar
275 1.07 32 1015-1088 70-75
375 1.14 32 1088-1160 75-80
2735 1.07 35 1160-1233 80-85
TABLE 3-1
FIG. 3-10
1 1/4"
Blade
± 1 mm (3/64”)
3.0 mm (1/8”)
Blade