Wood-mizer LT15SC M2 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 27 / 123

Safety & General Information
Cutting Capacity
Safety & General Information HDSdoc020719 1-15
1
See
The Blade Handbook
for blade hook angle, tooth height, and tooth set specifications.
1.9 Cutting Capacity
See Table 1-4. The log size capacities of the LT15SC sawmills are listed below.
See Table 1-5. The performance capacity of the LT15SC sawmill is listed below. Peak cutting rates
are measured in 12” (30 cm) wide red oak and represent the capability of the sawmill only. Rates
based on using Tru-Sharp 1 1/4” x .042 blades.
1.10 Engine/Motor Specifications
See Table 1-6. The power options available for the LT15SC sawmills are listed below.
See Table 1-7. See the table below for power supply specifications for the LT15SC sawmill.
2
TRU•SHARP™ “F” blades use a 9/29 profile (9° hook angle and 29° back angle) and are
designed to cut frozen and/or extremely dense, hard-to-cut wood. Standard TRU•SHARP™
blades use a 10/30 profile.
3
Customer may choose preferred blade.
Max.
Diameter
Max.
Length
1
1
Each additional bed frame segment adds approximately
195 cm ( 6’ 5” ) to length capacity.
LT15SC S2 70 cm 3,5 m
LT15SC S3 70 cm 5,4 m
LT15SC S4 70 cm 7,3 m
LT15SC M2 70 cm 5,2 m
LT15SC M3 70 cm 7,9 m
LT15SC M4 70 cm 10,6 m
TABLE 1-4
Model Cutting Rate
LT15SC E11, G18, D10 11 ft./min (3.3 m)/min.
TABLE 1-5
Engine/Motor Type Manufacturer Model No. Specifications
7.5 kW Motor Indukta, Poland PSg-132S-2B 3 x 400V, 50 Hz
11 kW Motor Indukta, Poland PSg-132M-2A 3 x 400V, 50 Hz
Up/Down Motor
0.55kW
Besel SKh71X-4C2/HPS08 3x 230/400VAC, 50Hz
Power Feed Motor
0.55kW
Dutchi Motors,
Holland
DMA 80K4 230/400V, 50 Hz
TABLE 1-6