Page
51
APPENDIX B: Using a Direct Connection
Introduction
A direct connection should only be used when a LAN (local area network) is not
available. A direct connection to any unit can be difficult if you're not familiar with
setting static IP addresses. Fortunately, this unit has a DHCP server embedded in it,
which will make a direct connection much easier. All of these instructions may not
be needed in your particular situation, but following them ensures success.
Using a Direct Connection
1.
Disconnect the Computer from any LAN.
2.
Disconnect the UNIT from any LAN.
3.
Connect the unit to the host computer through either a standard network
"patch" cable or "crossover" cable. The unit will recognize which is being
used automatically.
4.
Turn the unit on, and set the unit for direct mode and DHCP. This can be
done in the Version and Ethernet Menu, Connect: Direct. For more
information, see the Version and Ethernet Menu description in Chapter 4.
Note: If there are static values already entered for the IP Address and IP
Mask, you may want to write them down so you can restore those
settings later
5.
On your host computer, close any running applications, especially those
using the internet or maintaining a VPN (virtual private networking)
connection.
6.
If your host computer has multiple network interfaces (such as wireless and
wired Ethernet), disable the ports you will not be using (especially wireless
port(s)).
7.
Restart your computer.
8.
Start the AMP1-16-M Manager.
9.
Your unit should eventually appear in the Units Responding window of the
Wohler AMP1-16-M Manager PC program. Depending upon your computer, it
Important:
If you have not yet installed the AMP1-16-M Manager setup software into
your PC you must do that first. Please see the download and installation
instructions in Appendix A before continuing.
