Page
5
CHAPTER 1: Quick Start
Introduction
Overview
The AMP1-16-M is a 1RU, 16-channel, 3G/HD/SD-SDI audio monitor. This unit
comes with two 2.4” graphics screens that work together to display 16 channels of
audio level metering. You can both visibly and audibly monitor any de-embedded
channel pair or pairs of the selected 3G/HD/SD-SDI input signal. The AMP1-16-M is
small, low-cost, and simple to operate. Configuration is simple and you can easily
copy any configuration to other AMP1-16-M units.
Note that very little configuration should be necessary. We have already configured
the unit to the most commonly requested settings. However, should you need to
change these settings, you can access the unit either through the front panel menu
system, or remotely through a PC program called the Wohler AMP1-16-M Manager.
Safety
Instructions
1.
Read, keep, and follow all of these instructions; heed all warnings.
2.
Do not use this equipment near water.
3.
Use only a dry cloth to clean the equipment.
4.
Do not block any ventilation openings.
5.
Do not install near any heat source such as a radiator, heat register, amplifier, or
stove.
6.
Do not attempt to plug the unit into a two-blade outlet (with only two prongs of
equal width).
7.
Protect the power cord from being walked on or pinched, particularly at plug
connections on the equipment and at the socket.
8.
Use only the attachments/accessories specified by the manufacturer.
9.
Unplug the equipment during lightning storms or when unused for long periods
of time.
10. Refer all servicing to qualified service personnel. Servicing will be required
under all of the following conditions:
Important:
By design, this monitor will only plug into a three-prong outlet for your
safety. If the plug does not fit into the outlet, contact an electrician to
replace the obsolete outlet.
