Bedienungsanleitung Steuerung S4_2006_09_25-neu.doc
Page 54 / 83
© wodtke GmbH Tübingen. All rights reserved. Subject to change without notice.
Month of issue xx/2007
Art. No. 950 281
6.
Open the firedoor, take out the grate and
vacuum burner pot. Lift burner pot out and
clean. Clean combustion air holes with a
suitable
implement
(screwdriver)
if
necessary.
[An
dieser
Stelle
ist
im
Deutschen ein Fehler – Anm. d. Ü. XX]
7. Vacuum firebox, pot holder and base plate
thoroughly.
Important notes: When inserting the burner
pot again make sure it rests fully on the pot
holder. Remove any combustion residues on
the pot or pot holder. Check that the burner
pot is firmly seated in the pot holder and
doesn’t side-wobble by more than 1 to 2 mm
– if it does, you will need to replace the
burner pot (wearing part). The “burner nose”
must point forward.
8. Release both screws on inlet grille and
remove grille.
9. Release both screws on inspection cover
and remove cover.
10. Remove ash using the ash scraper or a
vacuum cleaner.
Mind hot ash and hidden glowing
embers!
11.
Inspect flue gas fan for soiling.
Note: In models of the Topline series the
flue gas fan is screwed onto the stove in the
rear left-hand area. You can check for soiling
either by looking from behind into the flue
outlet (pull the stove forward, away from the
flue gas connector for this purpose) or by
dismounting the fan motor (first remove side
panel at the rear left for this purpose).
Only clean the fan if necessary (see
Chapter 9.10).
See Chapter 9.10 for further service
procedure.
