Witt 24310037, Инструкции по установке и использованию

Страница: 42 / 52

42 42
CLEANING AND MAINTENANCE
6
GENERAL ADVICE
• Before you begin cleaning, you
must ensure that the appliance is
disconnected from the electrical
power supply.
• When the appliance is not being
used, it is advisable to keep the gas
tap closed.
• The periodical lubrication of the gas
taps must be done only by specialized
personnel.
• If a tap becomes stiff, do not force;
contact your local After Sales Service
Centre.
• It is advisable to clean when the
appliance is cold and especially when
cleaning the enamelled parts.
• Avoid leaving alkaline or acidic
substances (lemon juice, vinegar,
etc.) on the surfaces.
• Avoid using cleaning products with a
chlorine or acidic base.
•
Important: The use of suitable
protective clothing/gloves is
recommended when handling or
cleaning of this appliance.
WARNING: When correctly installed,
your product meets all safety
requirements laid down for this type of
product category. However special care
should be taken around the rear or the
underneath of the appliance as these
areas are not designed or intended to
be touched and may contain sharp or
rough edges, that may cause injury.
ELECTRONIC PROGRAMMER
DISPLAY CLEANING
Clean the programmer display using a soft
cloth, warm water and neutral soap, or
a soft cloth with a liquid detergent (non-
abrasive).
When cleaning, be careful to move the
cloth in one direction only.
Then wipe the display with a damp cloth
and dry it with a soft cloth.
IMPORTANT:
DO NOT use chlorine-based or acid-
based cleaning products, abrasive
products or non-neutral detergents as
they may cause irreparable damage to
the surface. DO NOT spray cleaning
liquids directly on the programmer
display.
STAINLESS STEEL AND
ALUMINIUM PARTS, PAINTED
AND SILK-SCREEN PRINTED
SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be
cleaned very carefully to avoid scratching
and abrasion. You are advised to use a
soft cloth and neutral soap.
CAUTION: Do not use abrasive
substances or non-neutral detergents
as these will irreparably damage the
surface.
Note: Continuous use may cause a
change in the glaze around the burners,
corresponding to the areas exposed to
the heat.
Important: The manufacturer declines all liability for possible damage caused by
the use of unsuitable products to clean the appliance.
Attention!
The appliance gets very hot, mainly around the cooking areas. It is very important
that children are not left alone in the kitchen when you are cooking.
Do not use a steam cleaner because the moisture can get into the appliance thus
make it unsafe.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven
door glass since they can scratch the surface, which may result in shattering of
the glass.