Witt 24310037, Инструкции по установке и использованию

Страница: 23 / 52

23 23
A
Fig. 3.1
CONNECTION OF THE POWER SUPPLY CABLE
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
To connect the supply cable:
•
Unhook the terminal board cover by inserting a screwdriver into the two hooks “ A ” (fig.
3.1).
• Open the cable gland by unscrewing screw “ F ” (fig. 3.2), unscrew the terminal
screws.
• Insert the feeder cable of the suitable section (as described in the next chapter) into
the cable gland.
• Connect the phase, neutral and earth cables to the terminal block according to the
diagram in figure 3.3.
• Pull the feeder cable and block it with cable gland.
• Close the terminal block cover (check the two hooks “ A ” are correctly hooked).
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws
fixing the cover plate behind the terminal block.
NOTE: The earth conductor must be left
about 3 cm longer than the others.
FEEDER CABLE SECTION
Type “H05RR-F”
220-240V ac 3 x 1,5 mm
2
(*) (**)
(*) Connection possible with plug and outlet
(**) Connection with wall box connection.
F
230 V
PE
N L
Fig. 3.3
Fig. 3.2
220-240V ac