Witt 24310037, Инструкции по установке и использованию

Страница: 18 / 52

18 18
GAS CONNECTION WITH RIGID PIPES OR A FLEXIBLE PIPE
The gas connection is made up of:
•
the terminal fitting of the inlet pipe (right-hand or left-hand);
• the conical pipe fitting (if not already fitted on the inlet pipe, it is supplied with the
appliance in a separate kit);
• sealing washer.
When connecting the cooker to the gas supply with rigid pipes or a flexible pipe,
make sure that
• you use rigid pipes or a flexible pipe complying with applicable local regulations. The
flexible pipe shall be of the correct construction for the type of gas being used.
• if compression fittings are used, you tighten them firmly using two spanners (fig. 2.2).
• the connection with rigid metal pipes does not cause stress or pressure to the gas
piping.
• the flexible pipe is not under tension, twisted, kinked or too tightly bent, neither while
the appliance is in use nor while it is being connected or disconnected.
• the flexiple pipe does not exceed 2000 mm in length (or refer to applicable local
regulations) and does not come into contact with sharp edges, corners or moving
parts. Use a single flexible pipe only; never connect the cooker with more than one
flexible pipe.
• the flexible pipe can easily be inspected along its entire length to check its condition;
if it has an expiry date, it should be replaced before that date.
• if using a flexible pipe which is not entirely made of metal, make sure that it does not
come into contact with any part of the cooker with a surface temperature of 70°C or
above (or refer to applicable local regulations).
• the hose is not subject to excessive heat by direct exposure to flue products or by
contact with hot surfaces.
• the rigid or flexible pipe is replaced if it shows signs of wear or damage.
• a gas pressure regulator, in compliance with the applicable local regulations, is
installed when connecting to an LPG cylinder.
• you inform the customer that the cylinder valve or the supply valve immediately by
the appliance should be closed when the cooker is not in use.
• you inform the customer that the rigid or flexible pipe should not be subjected to
corrosion by acidic cleaning agents.