continuing to apply the brake lever. (N.B. use
of a thread locking compound is
recommended on the caliper fixing screws).
Warning:
If you are unsure about any part of the brake installation process you
should seek advice from a Wisper service center or qualified mechanic.
Caution:
The pads and rotor must be kept clean and free from oil or grease based
contamination. If the pads become contaminated you must discard them and
replace them with a new set. A contaminated disc should be cleaned with a
proprietary brake cleaning solution.
3.7. Stem and handle bar clamp 905 and 705
3.7.1 Your bike has been fitted with an adjustable handlebar and stem clamp that allows
you to change the angle and height of the bars to find the most comfortable riding
position.
3.7.2 The handlebars can be adjusted before you use the bike by slackening the four
clamp bolts (shown in the picture below) using a 4mm Allen key. Once a comfortable
position is
achieved, securely tighten the four clamp bolts evenly, ensuring an even
gap is left between the two halves of the clamp housing, and the serrations on the two
halves of the clamp mate correctly with the fixed part of the stem. Tighten the four
bolts to a torque setting of 12Nm
Fig 5
3.7.3 To alter the rake of the handle bars, slacken the central Allen screw in the side of
the stem
and rotate the stem up or down until the desired position is obtained.
Retighten the Allen screw securely to 17-18.5 Nm.
20
Содержание 705 TORQUE
Страница 2: ...Contents 2 ...
