Bike Storage Stand
Lusso-mM
instructions manual
(ver.1.0 2018/3)
How To Assemble
1
2
3
4
Rear Tire Holder
Step-Bar
Flat Wasaher
Spring Washer
M6x30 Bolt
Insert the Rear Tire Holder into the Step-
Bar (no specific direction) and fix it with
four M6x30 Bolts.
Insert the Tire Holder into the Step-Bar,
do not attach underneath yet.
Lower
Frame
Insert the Lower Frame into
the Step-Bar, and fix it with
four M6x30 Bolts.
Joint the Upper Frame to the
Lower Frame, and fix them with
two shorter M6x25 Bolts.
M6x25 Bolt
Flat Washer
Dome Nut
Flat Washer
Put the Front Tire
Holder at the top of
the Upper Frame, and
temporarily hold it with
the Knob Bolts.
You will adjust the
positions of the Tire
Guide - A and C in the
next step.
Front
Tire
Holder
Knob Bolt
Tire Guide - A
This is also the same.
Insert the frame into the Step-
Bar, do not attach behind it.
!
Tire Guide - B
Tire Guide - C
Tighten each
bolt equally and
alternately.
Do not try to tighten
just one bolt firmly.
You may not be able
to screw other bolts.
!
Please be advised
the stand may fall
backward at this
moment due to the
imbalance of the
stand at this point.
This stand is NOT compatible with a bike equipped with a mud guard.
Do not use this stand for any other purpose than instructed.
!
If your bike has long wheelbase
such as large 29" wheel MTB,
install the optional Extention
Bars between the upper and
lower frames.
This extends the frame length
100mm.
Upper
Frame
[Extention Bar]
Required Tools :
4mm Hex Wrench, 10mm Spanner
Flat Wasaher
Spring Washer
M6x30 Bolt
!
