Wisper 705 TORQUE, Руководство пользователя

Страница: 23 / 30

3.10. Quick release saddle height adjustment
3.10.1 Your Wisper bike has been fitted with a quick release saddle post fitting to
facilitate the movement of the saddle height.
3.10.2 It is important that the knurled nut on the fitting is tightened so the post will not
move in
the bike tube. Make this adjustment with the quick release lever in the
open position.
3.10.3 Adjust the seat to the correct height and close the lever firmly. When you sit on
the saddle
there should be no vertical movement at all in the saddle post beyond the
seat post suspension movement. Never apply grease to the saddle post.
Fig 11
3.11. Rims and spokes
3.11.1 It is essential to have your spokes checked and tightened after 300 miles. This is a
free service provided by your supplier. If this service has not been undertaken at the
correct
time, this may cause damage to the wheels and spokes that will not be
covered under our Warranty.
3.12. Chain and drive wheel removal
3.12.1 To completely remove the rear wheel, it is necessary to disconnect the main motor
cable connecting the motor to the bicycle electrical system. This operation is best
achieved by turning the bicycle upside down.
3.12.2 Locate the motor cable where it emerges from the centre of the wheel axle on the
left hand
side of the bicycle, slide back the top hat protector to locate wheel nut.
23