28
WPS-500/750-PTZ-A Installation Manual
4.8. System Setup Menu Overview
• CLEAR MEMORY
Clear all programmed settings for positioning or automatic movement. Other settings will not change.
• RESTORE DEF SETTING
Returns all settings to factory default. PTZ ID will revert to the dip switch setting.
• COLOR SYSTEM
Select the color system output from “NTSC” or “PAL”.
• DOME RESTART
Press left or right on the PTZ joystick to reboot the camera.
•
IR MODULE SETUP (ONLY ACTIVE IN WPS-750-PTZ-A)
Configure IR illumination settings.
4.8.1. Clear Memory Instructions
1. Use the PTZ joystick to scroll to the “CLEAR MEMORY” setting and press “Iris+” to enter the menu.
2. Press “Iris +” (“OPEN”) again when prompted, or “Iris-” to cancel and return to the previous menu.
4.8.2. Restore Default Settings Instructions
1. Use the PTZ joystick to scroll to the “RESTORE DEF SETTING” setting and press “Iris+” to enter the menu.
2. Press “Iris +” (“OPEN”) again when prompted, or “Iris-” to cancel and return to the previous menu.
4.8.3.
Dome Restart Instructions (Reboot)
1. Use the PTZ joystick to scroll to the “DOME RESET” setting.
2. Press “Iris+” to reboot the camera. No settings will be modified.
4.8.4.
IR Module Setup Instructions (ONLY ACTIVE IN WPS-750-PTZ-A)
1. Scroll to and then press right on the PTZ joystick to enter the “IR MODULE SETUP” menu:
2. Configure each setting as desired:
•
IR CONTROL:
Press left or right on the PTZ joystick to select the IR mode from:
•
AUTO: The camera will turn IR on and off as needed based on the detected light level.
• ON: IR illumination will remain on at all times.
• OFF: IR illumination is disabled.
•
IR SW DELAY:
Press left or right on the PTZ joystick to select the time the camera will wait to turn IR on or off when set
to AUTO mode. Select from 5, 10,15, 30, or 45 seconds.
3. Press “Iris -” (“CLOSE”) to save settings and return to the previous menu.
Содержание 750-PTZ-A-WH
Страница 32: ...141223 1121 2014 Wirepath Surveillance...
