Wirepath Surveillance 750-PTZ-A-WH, Руководство по установке

Страница: 19 / 32

19
© 2014 Wirepath Surveillance
WPS-500/750-PTZ-A Installation Manual
4.5. Control Options Menu Overview
• DOME ADDR SETUP
Allows the RS485 address to be changed electronically or set based on the dip switch positions. (Dip switch settings
can be found in section “3.9. Dip Switch Configuration” on page 15.)
• AUTO FLIP
When enabled, the camera rotates 180 degrees when it reaches the tilt position threshold.
• PROPORTIONAL SPD
Causes the pan/tilt speed to slow as you zoom in, making it easier to set the view more accurately in a tight field of
view. Turn on or off.
• PAN REVERSE
When turned ON, pan movements are reversed, so moving the controller in the LEFT direction causes the camera to
move in the RIGHT direction.
• TILT REVERSE
When turned ON, tilt movements are reversed, so moving the controller in the UP direction causes the camera to
move in the DOWN direction.
• VECTOR SCAN STILL
Allows the user to setup scan based on scan speed, dwell time, and pre-shot (settable staring position).
• AUTO FOCUS
Keeps the camera focused on subjects in the camera’s field-of-view. Turn on or off.
• AUTO AE
Set whether Automatic Exposure (AE) remains active when the dome device changes its pan or tilt or zoom.
• PRESET AF
Set whether the camera auto-focuses or not when vector scan is running.
• -2 TILT LIMIT
Turn ON to restrict camera movement beyond 0.0 degrees. When the setting is OFF the camera can tilt up to -2.0
degrees.
• SPEED LIMIT
Changes the pan speed from slow to fast. When set to ON, the pan speed is slow. When set to OFF, the pan speed is
fast. The speed limit feature is very useful when operating the camera using a PTZ joystick.
4.5.1. Dome Address Setup Instructions
The RS485 address can be set physically or electronically. The physical dip switches on the camera assembly are ideal for
initial setup, but the address may be changed in the software later if needed.
IMPORTANT! Changing the address of the camera may cause a loss of PTZ communication. If the address is changed to a
different ID using the OSD menu, the address for the camera must also be changed in the PTZ controller.
1. Select “DOME ADDR SETUP” and press “Iris +” (“OPEN”) to enter the sub-menu.
2. Set the “ADDR TYPE” field from “PHYSIC” (uses the dip switch settings) to “LOGIC” (use the menu setting).
3. Highlight the “DOME ID” field and press “Iris +” (“OPEN”) to select the desired address. Press “Iris -” (“CLOSE”) to save
the new address.
4. Select whether the address is displayed on the camera view using the “BROADCAST ID” setting (“ON” or “OFF”).
5. Press “Iris -” (“CLOSE”) to close the sub-menu. The camera will save the new address and stop responding to
commands at the old one.
6. Change the address of the camera in the PTZ controller to regain control. If needed, power the camera off and back
on while viewing the video feed to see the new PTZ address in the boot up messages.