WirelessHART Rosemount 2160 WirelessHART, Справочное руководство, Страница: 75 / 100

Reference Manual
00809-0100-4160, Rev AB
March 2010
6-5
Rosemount 2160
RE-ASSEMBLY
PROCEDURES
IMPORTANT
The V-Seal must be installed at the bottom of the housing.
Attach the Sensor to the
Wireless Housing
1. Insert the sensor connector into the top of the sensor.
2. Reconnect the antenna wiring.
3. Gently slide the assembly into the housing, making sure the pins from
the PlantWeb housing properly engage the receptacles on the assembly.
Avoid trapping the sensor wires.
4. Tighten the captive mounting screws.
5. Attach the PlantWeb housing cover and tighten so that metal contacts
metal.
Install the Terminal Block
1. Gently slide the terminal block into the housing, making sure the pins
from the PlantWeb housing properly engage the receptacles on the
terminal block.
2. Tighten the captive screws on the terminal block.
3. Attach the Wireless PlantWeb housing cover and tighten so that metal
contacts metal.
Re-assemble to the
Process Flange
1. Inspect the o-rings, if used. If the o-rings are not damaged, reuse them.
Replace o-rings that show any signs of damage, such as nicks, cuts, or
general wear.
NOTE
If you are replacing the o-rings, be careful not to scratch the o-ring grooves
when removing the damaged o-rings.
2. Install onto the process flange.
3. Install the appropriate flange bolts.