Winmate FM12Q, Руководство пользователя

Страница: 93 / 96

91
Chapter 5: Vehicle Mounting
Vehicle Installation
Office Test / Evaluation
With Ignition Without Ignition
Power Mode Ignition-On mode AC/DC Mode
AC/DC
Mode
AP to
switch
Auto-On Auto-On is ON Auto-On is ON
Auto-On is
OFF
BIOS
switch
Trigger
On
Ignition On
Signal
√ √
X
Power
Button
X X
√ (press for 2 sec)
On Delay 0 Second (Default) adjustable by AP X
Turn Off
Trigger
Off
Ignition Off
Signal
√
X X
Power
Button
√ √ √
First time use: Install all
the power cables require
for testing. Switch the
power switch On, located
on the dock and then the
device will Auto On / boot
up in 10 second.
5.4.4 Power Cable Routing
There are many cables available for the FM12Q including power cable, CAN Bus cable, or USB
cable. To secure these cables, there are five cable clamps secured the FM12Q vehicle dock to
prevent the cable strain.
To secure audio, power, and I/O cables perform the following
action:
1. Determine the proper strain relief cable clamps; there are
different sizes of the clamps depending on the thickness of
the cable. For example, the largest clamp is designed to
secure the power cable.
2. Remove the cable clamps from the vehicle dock by releasing
the screw. Put the screw and save in it the secure location.
3. Slide the clamp over the cable.
4. Refasten the cable clamp to the dock, adjust the tension in
the cable to allow it to be connected and disconnected when
needed.
5. Repeat this step until all cables are secured to the dock.