Winmate FM12Q, Руководство пользователя

Страница: 7 / 96

5
Preface
CE Notice (European Union)
This device has been tested and found to conform to the limits set for a Class B product.
• EN 55022
— “Limits and Methods of Measurement of Radio Interference Characteristics of
Information Technology Equipment”
•
EN 55024
— “Infor
mation technology equipment - Immunity characteristics - Limits and
methods of measurement”
•
EN 61000-3-2
— “Electromagnetic compatibility (EMC)
- Part 3: Limits -
Section 2”
• EN 61000-3-3
— “Electromagnetic compatibility (EMC)
- Part 3: Limits -
Section 3”
•
EN 60950
— “Safety of I
nformation Technology Equipment
”
.
• EN 55022 Emissions requirements
RF Exposure Information (SAR)
This device is compliance with SAR for general population /uncontrolled exposure limits in
ANSI/IEEE C95.1-1999 and had been tested in accordance with the measurement methods and
procedures specified in OET Bulletin 65 Supplement C.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device was tested for operations with the device contacted directly to the human
body to the back side of the EUT. To maintain compliance with FCC RF exposure compliance
requirements, avoid direct contact to the transmitted antenna during transmitting.
IC Regulations
Le présent appareil est confo
rme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
(1)
l’appareil ne doit pas produire de brouillage, et
(2)
l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.”
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired
operation of the Device.
This Class B Digital Apparatus Complies with Canadian ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
The device could automatically discontinue transmission in case of absence of information to
transmit, or operational failure. Note that this is not intended to prohibit transmission of control or
signaling information or the use of repetitive codes where required by the technology.
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful
interference to co- channel mobile satellite systems; the maximum antenna gain permitted (for
devices in the bands 5250-5350 MHz and 5470-5725 MHz) to comply with the e.i.r.p. limit; and The
maximum antenna gain permitted (for devices in the band 5725-5850 MHz) to comply with the e.i.r.p.
limits specified for point-to-point and non-point-to-point operation as appropriate, as stated in section
A9.2(3). In addition, High-power radars are allocated as primary users (meaning they have priority)
of the band 5250-5350 MHz and this radar could cause interference and/or damage to LE-LAN
devices.
The County Code Selection feature is disabled for products marketed in the US/Canada. For product