Winco DX100F4, Инструкция по установке и эксплуатации

Страница: 14 / 24

14
OPM-115
REV A
THE HIGH VOLTAGE “WILD” LEG IS. IT MUST BE IN THE SAME
LOCATION ON THE LINE SIDE AS IT IS ON THE GENERATOR SIDE.
(i.e. if it’s on L-3 on the line side it must be on G-3 on the generator
side).
NOTICE:
If for any reason during the check out procedure the voltage and
frequency are not correct, depress the STOP/RESET button and
correct the trouble before proceeding.
5. Stopping - There are two ways to stop the unit when it is in the
manual mode. Pressing the STOP/RESET button will stop the unit
immediately. Pressing the AUTO mode button will stop the unit but only
after the cool down timers have timed out and there is no remote start
signal being sent to the unit.
AUTO MODE
To activate the automatic start mode you will just need to depress the
AUTO button, the LED indicator beside the button confirms that the unit
is in automatic mode.
To test the Automatic Transfer Switch, follow the instruction on the
operator’s manual that came with the transfer switch. If you get a fault
during the initial start up or prior to start up, it is most likely a false
warning light. Simply reset the ATS start over.
Once you have completed testing of the ATS, be sure you ALWAYS
leave the system in the standby mode,unless servicing the unit. For
standby operation, press the AUTO button on the front of the control.
The green light should light up next to the AUTO button.
NOTE: For setting the exerciser circuit, for all ATS, see the operator’s
manual shipped with the ATS.
MAINTENANCE SCHEDULE
SERVICE INTERVALS
Check Engine Oil Level Daily
Check Coolant Level and for Leakage Daily
Check Air Filter Daily
Check Electrolyte Level in Battery and Clean Terminals 6 Months
Drain Water from Fuel Pre-Filter 150 Hours
Check Belts and Belt Tension 300 Hours
Check Oil Vapor Filter 300 Hours
Change Oil 600 Hours
Change Oil Filters 600 Hours
Change Fuel Filters 600 Hours
Change Fuel Prefilter 600 Hours
Check Exhaust System for Damage 6 Months
Clean Fuel Tank 6 Months
Change Auxiliary Member Belt 1200 Hours
Change Air Filter (depending on conditions) 1200 Hours
Change Coolant 1200 Hours
Change Oil Vapor Filter 2 Years
Clean Turbocharger 1200 Hours
Adjust Play in Valve-Rocker Arms and Pump-Rocker Arms 1200 Hours
* There are additional maintenance items and explanations in the
engine operator’s manual. Read thoroughly before operating this unit.