Wilo SiFire Easy, Инструкция по установке и эксплуатации

Страница: 70 / 116

English
60 WILO SE 01/2018
DANGER! Risk of fatal injury!
To change the DIP switch position it is necessary
to open the protection on the rear side of the
electronic control inside the switchgear. The DIP
switch setting must be done with the switchgear
main switch QS on Fig. 14 switched OFF
.
10.8 Switchgear for diesel pump – Remote alarms
Fig. 16
INSTRUMENTS Push button 18 on Fig. 15 to see the values
A/B Batteries Ammeters Full scale current 99 A connected with the battery chargers
A/B Voltmeters For voltage from 9 up to 38 Volt connected with the battery chargers
Total / partial hour meter Displays hours and minutes
Tachometer Full scale 9990 rpm
Fuel level indicator Not used – only alarm for low level
Water o oil thermometer Displays engine oil or water temperature 30-140 °C
Oil pressure gauge Displays engine oil pressure up to 9 bars
A/B batteries startups counter Displays the number of startups that have occurred on each battery up to 9999
Remote alarm Description Terminals on switch-
gear Symbol on HMI
Fig. 15
Switchgear failure It is detected when one of the fol-
lowing failures occurs:
• Occurred engine alarms
• Mains failure on switchgear
• Battery charger failure 90 - 8 17
Automatic mode switched off 90 - 91 6
Diesel pump start failure 90 – 94 23
Diesel pump in operation 90 - 92 8
Minimum fuel level 90 – 93 24
om_sifire_easy__4206362_ed02__1801_de_en_fr.book Seite 60 Freitag, 2. Februar 2018 10:23 10