Radio Module Configuration
Version 1.0 Rev B - 08/00
49
Setting Repeater Mode (Base Station Only)
When a base unit has repeater mode enabled, it re-transmits messages to all remotes in the
same RF group. When repeater mode is disabled, remote-to-remote traffic is allowed if
radio communication is possible and remotes are in the same non-zero RF group.
To set the repeater mode
1.
From the Main Menu, select
Radio Module Configuration.
The Radio Module
Configuration window is displayed.
2.
Select
Repeater Mode
.
3.
In the Repeater Mode entry field, scroll to select the desired setting based on the
following table.
4.
Press
Enter
.
off
Base unit does not re-transmit messages. This is the default
setting.
on
Base unit re-transmits messages received from one remote to
other remotes in the same RF group.
Radio Module Configuration
New Current Flash
Station Type Remote Unit Remote Unit Remote Unit
Station Rank (1-1000) 1 1 1
Center Frequency 2.4400 GHz 2.4400 GHz 2.4400 GHz
Security Password 1 (Hex) 1 1 1
Security Password 2 (Hex) 10 10 10
Security Password 3 (Hex) 100 100 100
Security Password 4 (Hex) 1000 1000 1000
Security Password 5 (Hex) 10000 10000 10000
Scrambling Code (Hex) 0 0 0
Acquisition Code (0-15) 0 0 0
Config Test Minutes (1-120) 30 30 30
Base Station Only Parameters
Repeater Mode -> off off off
System Symmetry Type Asymmetric Asymmetric Asymmetric
Dynamic Polling Level (1-100) 1
Remote Station Only Parameters
Remote Unit RF Group (0-63) 0 0 0
Reboot New RF configuration Press Enter to Execute
Save Current Config to Flash Press Enter to Execute
