00061810.DOC, Version 2.1
21/47
6.5 Connection and operation of the external sending card for the control system
LED Studio
6-5 Connection of the external sending card
1
Connect the DVI port of the sending card to the DVI port of the computer via the supplied DVI cable.
2
Connect the USB port of the sending card to the USB port of the computer via the supplied USB cable.
3
Connect the power supply unit to the power input jack [
DC 5V
] on the sending card and connect the
power cable to the power supply unit. Plug the mains plug to a mains outlet.
4
Thus the sending card is powered on and is in standby mode. The [
POWER
] indicator lights. By
disconnecting the unit from the mains it can be switched off.
Use only the included power supply unit. Always disconnect the mains connector when you wish to
change connections, move the unit to a different place or if it is not used for a longer period.
5
The [
SIGNAL
] indicator lights when the data link is established.
6
With the buttons [
�
] and [
�
] you can manually adjust the brightness of the displays connected in 16
steps.
6.6 Function test with the interfaces
After connecting the AIO network interface or the receiver interface to the displays, you can perform a first
functional test without having to run the respective software. Therefore you can check if all components are
connected correctly.
By pressing the button [
Test mode
] you can successively call different color and test programs which are
shown on the displays. Keep the button [
Test mode
] pressed for approx. 7 seconds to exit the test mode.
Please note that this mode is only applicable for color tests. There may be deviations when running
programs.
Содержание LSD-100
Страница 1: ...LED Video Curtain U s e r M a n u a l...
