00061810.DOC, Version 2.1
16/47
6. CONNECTIONS
�
General notes
Only use cables type CAT-5e or better between network card and AIO network interface or receiver
interface.
Do not use a network hub or switch or any other network extension to connect the AIO network
interface or receiver interface to the computer.
6.1 Control system LED Show T9
6-1 Connections LED Show T9
Data flow is from right to left and starts on the top right part. When configuring the software later on,
the order of the AIO network interface must be specified.
1
Connection displays AIO network interface
Connect the AIO network interface to the displays as shown above. For this purpose, connect each of
the 15-pin data signal outputs of the interface to the 15-pin data signal inputs of the displays: Fasten the
locknuts on the connectors.
Each data cable controls 128 (width) x 16 (height) pixels.
If needed, a 1.5 meter signal extension cable may be used (optional accessory).
2
Power supply AIO network interface
Power supply of the AIO network interface is via one the displays. Connect the 2-pin jack with the
indication [
Connect to receiving controller
] of one of the displays to the corresponding 2-pin jack of
the AIO network interface. Fasten the locknuts on the connectors.
Содержание LSD-100
Страница 1: ...LED Video Curtain U s e r M a n u a l...
