Kunststoffschweißtechnik
Starting and Operating
Chapter 5
19.09.11
Working Instructions WIDOS 5500 CNC 3.0
Page 33 of 78
Display:
2
nd
line:
insert heating elem
repeat planing
Button <Start>
by pressing the button <Planer>, the planing process
is repeated
Insert the heating element in the machine, take care that it lies in the zone
of the throat of the tear-off bar (Chapter: 4.3). and press button <Start>
Display:
2
nd
line:
closing machine
measuring dragpress.
after a few seconds, the display changes
Display:
2
nd
line:
bead up
Ps=000 Pi=000 P
0
=0.0
The bead up pressure is displayed
Display shows alternating bead up pressure and heating element temperature
Display:
2
nd
line:
bead up
heat.elem.t. 000°C
The heating element temperature is displayed
after the bead height being reached, the display changes
Display:
2
nd
line:
heat up Taw= 0000s
heat.elem.t. 000°C
Remaining heating time
Heating element temperature
5 seconds before end of the heating time you will hear several beeps
Display:
2
nd
line:
change over
remove heating elem.
Take heating element out of the machine
after a few seconds, the display changes
Display:
2
nd
line:
change over
after a few seconds, the display changes
Display:
2
nd
line:
ramp Tf= 000s
Ps=000 Pi=000 P
0
=0.0
Remaining pressure build-up time (sec)
