Kunststoffschweißtechnik
Starting and operating
Chapter 5
14.01.2015 Working
Instructions
WIDOS 4002 S CNC 3.0
Page 36 of 92
Display:
2. line:
Print SD
_
Either:
Press <Start> several times,
or:
Wait until the basic menu appears after a while
Display:
2. line:
WIDOS 4002 S CNC
09:43 03.05.2007
„
B a s i c m e n u “
5.11. Administration of the welding data
The battery-buffered CNC memory (RAM) can store about 400 weldings.
Make sure not to go over this quantity (in the display the error message
"memory full“ appears) because otherwise the first stored welding will be over-
written.
If necessary, copy the welding data on SD-card and read out in time.
5.12. Setting the welding angle on the clamping tool
5.12.1. Clamping tool
Image showing the right clamping tool
In order to adjust the angle, first remove screw
3
.
Detach screws
1
and
2
, then turn the clamping tool
around the rotary point onto the desired angle.
Markings have been fixed to the table for angles 11.25°
and 15°, other angles must be adjusted by goniometer.
Afterwards retighten screws
1
and
2
.
Rotary point for clamping tool
