Kunststoffschweißtechnik
Starting and operating
Chapter 5
14.01.2015 Working
Instructions
WIDOS 4002 S CNC 3.0
Page 29 of 92
Display:
2
nd
line:
opening machine
after a few seconds, the display changes
Display:
2
nd
line:
insert heating elem.
repeat planing
Either:
Swing the heating element with its lug between the puller claws (chapter:
5.2) and press <Start> afterwards.
Or:
repeat the planing process, (from:
)
Display:
2
nd
line:
closing machine
measuring dragpress.
after a few seconds, the display changes
Display:
2
nd
line:
bead up
Fs=000 Fi=000 F
0
=0.0
The bead up force ( Fs= desired / Fi = actual / Fo = )
is displayed
Display shows alternating bead up pressure and heating element temperature
During adjusting time, you can switch into "manual adjusting mode" by pressing the button
„Enter“. The machine then remains under pressure until the "manual adjusting mode" is
stopped by pressing again the button „Enter“.
Now necessarily
remove the handle
from the heating element and store it
here in the frame.
Unless the handle is stored in the frame,
the machine gets stuck after heating and
the heating element is not swung out
automatically.
Display:
2
nd
line:
bead up
heat.elem.t. 000°C
The heating element temperature is displayed
after the bead height being reached, the display changes
