Whirlpool WED99HEDC0, Техническое образование

Страница: 60 / 100

4-12
n
HybridCare™ Dryer with Heat Pump Technology
COMPONENT ACCESS
To Remove the Drive Motor
1. Unplug dryer or disconnect power.
2. Remove drain hose from standpipe or laundry tub.
3. Perform the procedures on page 4-4, “Removing the Top
Panel” and “Removing the Console” prior to performing
the following steps.
4. Perform the procedures on page 4-7, “Removing the Front
Panel” prior to performing the following steps.
5. Perform the procedures on page 4-10, “Removing the Belt
and Drum” prior to performing the following steps.
6. Reach around to the back of the blower housing and
attached a 7/16” open-end wrench to the hex-end of the
motor shaft, and a ratchet with a 5/8” socket over the
hex-head nut on the blower wheel (see Figure 1).
7. Turn the blower wheel clockwise (shown by the
“REMOVE” arrow that is embossed on the front of the
wheel) and remove the wheel from the motor shaft (see
Figure 1).
Stabilize shaft
with 7/16” open-
end wrench
To remove, turn
CW with 5/8”
socket wrench
Figure 1
8 . Lift the locking tabs on the top and bottom of the motor
harness plug and disconnect the plug from the motor
terminals.
Removing the Drive Motor
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
9. Locate the front and rear motor clips as illustrated in
Figure 2 below. Using a small flat blade screwdriver, insert
the blade of the screwdriver into the pocket at the tip of
the clip. Pry the clips off the tab and remove.
Front Motor Clip
Rear Motor Clip
Figure 2
10. Lift motor from support brackets, slide shaft from blower
wheel housing and remove motor from cabinet.
Blower Shaft
Belt Pulley
Motor Connector
Figure 3
Tab
Place screwdriver
here to pry off clip
Clip