PARTS SUPPLIED
Questions? Call 1.800.561.3344 or visit www.GEAppliances.ca
WARNING
Fire Hazard
- Fire Hazard
WARNING
• Appliance installation must be performed by a qualified
installer.
• Install the appliance according to these instructions
and local codes.
•
DO NOT
install a clothes dryer with flexible plastic venting
materials. If flexible metal (semi-rigid or foil-type) duct is
installed, it must be UL-listed and installed in accordance
with the instructions found in “Connecting the Dryer
to House Vent” later in this manual. Flexible venting
materials are known to collapse, be easily crushed and
trap lint. These conditions will obstruct dryer airflow and
increase the risk of fire.
•
DO NOT
install or store this appliance in any location
where it could be exposed to water or weather.
• To reduce the risk of severe injury or death, follow all
installation instructions.
• Save these instructions. (Installers: Be sure to leave
these instructions with the customer.)
2 Strainer Screens/
Rubber Washers
2 Washer Hoses
1 Cable Tie
29-6443
06-22 GEA
Installation
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
–
Save these instructions for local electrical
inspector’s use.
IMPORTANT
–
Observe all governing codes and
ordinances.
• Install the appliance according to the manufacturer’s
instructions and local codes.
• Note to Installer –
Be sure to leave these instructions
with the Consumer.
• Note to Consumer –
Keep these instructions for future
reference.
• Appliance installation must be performed by a qualified
installer.
• This dryer
must
be exhausted to the outdoors.
• Before the old appliance is removed from service or
discarded, remove the washer and dryer doors.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Install the appliance where the temperature is above 50°F
for satisfactory operation of the appliance control system.
• Remove and discard existing plastic or metal foil duct
and replace with UL-listed duct.
• Service information and the wiring diagram are located
at the access panel.
NOTE:
The Rubber
Washers may be in
the water hoses
Unitized Washer/Dryer
29-6443
