Whirlpool WED99HEDC0, Техническое образование

Страница: 53 / 100

COMPONENT ACCESS
HybridCare™ Dryer with Heat Pump Technology
n
4-5
To Remove the User Interface
1. Unplug dryer or disconnect power.
2. Perform the procedures on page 4-4, “Removing the Top
Panel” and “Removing the Console” prior to performing
the following steps.
3. Pull the cycle selector knob off the switch shaft (see Figure
1).
4. Disconnect the two (2) harnesses from the user interface
(see Figure 2).
5. Remove the eight (8) 1/4” hex-head screws securing the
user interface to the console as illustrated in Figure 3.
6. Separate user interface from console assembly.
Removing the User Interface (UI)
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Figure 3
Console Assembly
User Interface
Console
Harnesses
Remove
selector knob
Figure 1
Disconnect
harnesses
Figure 2
REASSEMBLY NOTE: When reinstalling the user interface to
the console, only hand tighten the eight (8) hex-head screws
until snug. Using a power driver will strip the screw holes and
stress the capacitive touch user interface.