Whirlpool WED99HEDC0, Техническое образование

Страница: 59 / 100

COMPONENT ACCESS
HybridCare™ Dryer with Heat Pump Technology
n
4-11
Removing the Belt, Drum, and Rollers (continued)
10. Remove the five (5) 1/4” hex-head screws from the lint
duct as illustrated in Figure 6. Swivel the lint duct down
from the bulkhead and remove.
Swivel down and
remove lint duct.
Figure 6
11.
Remove the four (4) 1/4” hex-head screws securing the
front bulkhead to the side panels as illustrated in Figure 7.
Lift the bulkhead up off the side-panel tabs and remove.
Side Panel Tabs
Figure 7
12. Reach under the drum, (raise it as far as it will go), and
push the idler pulley arm, on the back of the drive motor,
to the left to relieve the tension on the belt, then remove
the belt from the pulley. See Figure 8.
Push
Remove Belt
From Pulley
Figure 8
13. Slide the belt off the front of the drum and remove belt.
14.
Lift the drum and remove it from the dryer cabinet.
To Remove a Roller
1.
Pry the sides of the triangular ring out of the groove in the
roller shaft with a small screwdriver (see Figure 9).
Figure 9
2.
Slide the roller off the roller shaft (see Figure 10).
Figure 10
3.
To remove the roller shaft, remove the 9/16” nut and
washer from the roller support, and remove the support
and remaining triangular ring. See Figure 11.
Figure 11
Triangular Ring
Roller Shaft
Nut & Washer
Roller Shaft & Ring
Remove 4 screws