PAGE 6
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DESTROY
Service Diagnostics Chart (cont.)
Washer
Recommended
Est. Time
Display
Function
Procedure
In Seconds
014
Drain pump and
If water is not being drained or
<10
recirc.
pump
†
on
recirculated, use service test load
for 25–30 seconds
control to test the drain pump.
See page 4.
015 Pause
N/A
5
016
Agitate for
Use service test load control to manually
5
5 seconds
test the motor. See page 4.
017
Low speed spin
Use service test load control to manually
5
for 5 seconds
test the motor. See page 4.
018
Spin for
Use service test load control to manually 30–40
20–30 seconds
test the motor. See page 4.
019
Agitate for
Use service test load control to manually
10
10 seconds
test the motor. See page 4.
020
Unlock lid
If lid does not unlock, use service test
5
load control to manually test the lid lock.
See page 4.
Total time in minutes
Appx. 3–4 mins.
†
On models without recirculation pump, only the drain pump will turn on in step 14.
Service Diagnostics Pass/Fail Indication
After the cycle completes, the Pass or Failure
status of each step in Service Diagnostics is
available by the following procedures:
Models without a cycle selection knob
Press the soil level or temp buttons. The
sequence step increments using the soil level
button and decrements using the temp button.
Models with a cycle selection knob
In addition to pressing the soil level or temp
buttons, rotating the cycle selection knob
clockwise increments through the cycle
functions while rotating counterclockwise
decrements through the available options.
On all models,
the display will flash between
the sequence function number and “PAS”
for Pass, “FAL” for Fail, or “---” if the machine
control is not capable of determining if a
function passed or failed; each will be
displayed for 1 second.
Exiting Service Diagnostics Mode
Press the POWER button. All loads will be
turned off and the washer will enter standby.
Fault Detection During
Service Diagnostics Execution
Some faults will stop the cycle execution
(see Fault And Error Codes charts on pages
8–10 for those faults [marked with ‡] that
stop the washer). If a fault is detected, the
washer will stop executing the cycle and the
step during which the fault was encountered
will remain on the display. If no action is
taken within 5–10 minutes, the display will
be cleared and the washer will enter
standby mode.
