Installation Manual: GT500 FRPP Supercharger System (750HP) (A1R2)
Last Updated: Aug 19
th
, 2010
Page 7 of 35
The fuel pump relay can be found in the bussed electrical center located on the passenger side, front
of engine compartment fuse panel
.
The fuel pump relay is located in position 21 as shown in the
inside cover of the bussed electrical center. Remove the fuel pump relay. (2011 bused electrical
center has changed see inside cover for fuel pump relay position)
Start the engine and allow it to idle until it stalls. If engine does not start, proceed to net step.
After the engine stalls, crank the engine for approximately 5 seconds to make sure the fuel injection
supply manifold pressure has been released.
Turn the ignition switch to the OFF position.
WARNING
!!
Batteries normally produce explosive gases. Therefore, do not allow flames, sparks
or lighted substances to come near the battery. When charging or working near a battery, always shield
your face and protect your eyes. Always provide ventilation. Failure to follow these instructions may
result in personal injury.
WARNING
!!
Keep out of the reach of children. Batteries contain sulfuric acid. Avoid contact with
skin, eyes or clothing. Also, shield your eyes when working near the battery to protect against possible
splashing of the acid solution. In case of acid contact with the skin or eyes, flush immediately with
water for a minimum of 15 minutes and get prompt medical attention. If acid is swallowed, call a
physician immediately. Failure to follow these instructions may result in personal injury.
3.
Disconnect ground cable from battery using an 8mm wrench.
4.
Disconnect power cable from battery using an 8mm wrench.
5.
Remove battery strap and remove battery from vehicle.
6.
Remove battery tray from vehicle.
7.
Disconnect the following factory electrical connectors:
Mass Air Flow Sensor element. Carefully pull red tab out, squeeze the connector and then pull the
connector away from connection.
