Installation Manual: GT500 FRPP Supercharger System (750HP) (A1R2)
Last Updated: Aug 19
th
, 2010
Page 26 of 35
86.
Remove the driver side fuel pump access cover by carefully lifting up with a flat head screw driver.
87.
Disconnect the fuel pump electrical connector (driver side).
!!
CAUTION
!!
If the liquid or vapor tube is damaged (torn, holes or delaminated), the affected
tube assembly must be replaced with a new tube assembly. Do not use aftermarket sleeving. Do
not re-adhere loose sleeving material.
!!
CAUTION
!!
When reusing liquid or vapor tube connectors, make sure to use compressed air to
remove any foreign material from the connector retaining clip area before separating from the tube.
Apply clean engine oil to the end of the tube before inserting the tube into the connector.
!!
CAUTION
!!
Fuel injection equipment is manufactured to very precise tolerances and fine
clearances. It is therefore essential that absolute cleanliness be observed when working with these
components. Always install blanking plugs to any open orifices or tubes.
88.
Disconnect the fuel tube quick connect coupling on the fuel pump (driver side).
