Installation Manual: GT500 FRPP Supercharger System (750HP) (A1R2)
Last Updated: Aug 19
th
, 2010
Page 29 of 35
To remove sensor
93.
Carefully cut clear tubing off yellow wire then depress tab and pull terminal apart.
94.
Remove sensor from new pump assembly.
95.
Reverse process to install sensor use provided shrink tubing and zip tie, heat black tubing to shrink over
terminal and tie wires up with zip tie (be careful that yellow wire is routed so it doesn’t rub on bracket)
!!!CAUTION !!!
Be careful not to heat fuel lines when shrinking heat shrink they can be damaged by heat gun!
Remove attachment screw holding
bracket then slide bracket upwards
to release Remove sensor assembly
from pump.
Cut zip tie holding wires together
2009 sensor shown yellow wire is on
bottom of 07-09 units and on top on
2010 sensor.
