I N P U T P A N E L
page 6
D-12 / July 2006
Source Selection
This section allows the user to select any source visible to its
X controller. A Preset memory location stores a single source signal for
recall via the PRESET switch. The REVERT switch causes the previously
selected input to be recalled. Sources may be taken at any time regard-
less of the input fader ON status.
SOURCE - this encoder (X controller) scrolls through the available
sources. The source list may be limited through the D-12 Visibility –
X Controller settings in the XPoint GUI.
TAKE - press this switch to assign the source displayed in the lower
source window to this input channel strip.
REVERT - press this switch to go back to the previously selected
source. Acts as an A/B source selector that toggles between the PRESET
and the selected source.
PRESET - used to store a source in PRESET memory. Spin the
SOURCES encoder until the desired source is displayed in the CURRENT
PAGE display. Then PRESS and HOLD the PRESET switch until the
PRESET button goes off and the CURRENT PAGE display reverts to the
actual current source. The PRESET source name is shown on the channel’s
LCD display.
ALTERNATE PAGE Display - top display shows the source for the
alternate page (see discussion of PAGE button on page 2-3)
CURRENT PAGE Display - lower display shows the channel strip’s
active source.
