Westgate DV48, Руководство пользователя

Страница: 33 / 60

33
1. Prior to installing the firebox liners, you will need to ensure the
Rear Brick Panel Support is in the correct position. The support
is located at the back of the firebox (see Figure 61) and can
be installed in two (2) positions. The upper position (using the
lower screw holes) is for the October Panels. The lower position
(using the upper screw holes) is for the Sandstone, Ledgestone,
and Porcelain Panels. Remove the Support, if necessary, and
Figure 61: Rear Brick Panel Support.
I
NSTALLATION
S
ET
-U
P
4. Install the Top Panel by
placing it on top of the
Rear Panel and behind the
Left Panel (see Figure 65).
Hold it with one hand or
have someone else hold
it for you while you place
the last panel. WARNING:
If this panel falls from this
location it will possibly
break or the paint work will
become chipped.
5. Place the Right Firebox
Liner Panel in the same
manner used for the Left
Panel (see
Figure 66). The
vertical edges
of the left and
right panels
should line up
with the front
edges of the
firebox sides.
The side panels
rest up against
the back panel
and hold the
top panel in
position.
Figure 62: Rear Firebox Liner Panel in Place.
Figure 63: Left Firebox Liner
Panel on Front Edge of Firebox.
Figure 64: Left Firebox Liner Panel in Place.
Figure 65: Top Firebox Liner Panel in Place.
Figure 66: Right Firebox Liner Panel in Place.
move it to the
a p p r o p r i a t e
placement.
3. Ensure the light covers provided with your kit are installed on
the Light Cover Bases at the rear of the firebox. The tabs on the
back of the Light Cover slide down behind the light cover base.
Refer to Figures 96 and 97.
2. Install the Rear Firebox Liner. This panel fits around the accent
lights and rests on top of the Rear Brick Panel Support. It will
stay in this location as you install the remaining panels. Refer to
Figure 62.
3. Install the Left Firebox Liner Panel; it sits on the bottom front
edge of the firebox (see Figure 63 & 64), a support bracket at
the lower rear of the firebox, and is held in by a retainer at the
top of the firebox. Adjust the panel retainers as required.