Westgate DV48, Руководство пользователя

Страница: 16 / 60

P
LANNING
Y
OUR
I
NSTALLATION
I
NSTALLATION OF
R
ECEIVER
:
Figure 22. Receiver Installation.
The Receiver is the heart of the remote control system. You need to access this receiver after installation to change
the batteries (for operation during a power failure), to program a new remote / receiver combination and to operate
a manual override should you lose your remote control or the batteries in the remote control lose their power.
The Receiver is connected to the fireplace with a wire harness that has a maximum length of 8 ft (2.4m). The
connection point on the fireplace is on the right side of the unit, where the gas valve and electronic ignition module
is located. Because of the 8 ft (2.4m) limitation in the wiring harness, the receiver needs to be mounted to the
right side of the fireplace. An electrical box is provided for the receiver. Mount this electrical box as you would any
electrical outlet or switch box. Thread the cable and connector through the back of the electrical box and connect it
to the rear of the receiver. Secure the receiver into the electrical box. Once the facing of the fireplace installation is
complete, install the receiver cover, supplied with the unit as shown. The receiver cover also functions as a switch
plate and allows for access to the program button, critical for remote control operation.
Review the section in this manual regarding the remote control operations for more information on the functions
of the receiver.
A
LLOWABLE
V
ENT
C
ONFIGURATIONS
:
The vent chart, in Figure 23, illustrates the vent configurations that have been tested and approved for use with
this appliance. 45˚ elbows are acceptable for this installation and may be used instead of 90˚ elbows. You may use
two (2) 45˚ elbows for every 90˚ elbow shown in this chart.
This appliance is also approved for use with 5” x 8” flex venting. For durability, safety and resistance to corrosion,
we recommend you use a flex venting made from stainless steel. Only use flexible venting that is approved for
fireplace applications. Flex vent runs must comply with the same limitations as the rigid vent chart shown here.
Flexible vent runs greater than 8’ total are not recommended. Mixed vent runs of both Flexible and rigid venting are
allowed providing all the proper connectors are utilized. See your vent providers’ catalogue for flex to rigid or rigid
to flex adaptor numbers.
The restrictor settings shown in Figure 23, are recommended. Installation factors such as altitude, prevailing
weather conditions such as temperature or wind, or the number of elbows used may affect your final restrictor
settings. Insufficient restriction may cause pilot outages or reduced efficiencies. Too much restriction may lead to
elevated operating temperatures, poor flame appearances, sooting or carbon deposits building up on burner effects
or window glass.
16