31
Adjustments
2. Turn the horizontal adjust-
ing knob (83) and move the
headstock to the desired
position.
3. Tighten the clamp bolt (E
1
).
Adjusting the Spindle Position
The drill table and the spindle are
already adjusted when delivered. If it is
required to readjust the parts, proceed
as follows:
Attention: Make sure the radial drill
press is switched off and unplugged
from power mains before undertaking
any adjustments.
1. Insert a test bar of 80 mm length
into the drill chuck and check with
a right angle ruler if there is a right
angle of the spindle to the drill
table.
2. Unscrew the set screws (45)
on both sides of the bench drill
assembly and adjust it.
3. Tighten both set screws with
the suitable hex wrench.
Test Bar
80 mm
Right
Angle
Part 45
Part 72
firm
slack
Part 83
E
1
Содержание ZQJ3116
Страница 1: ...Westfalia Bedienungsanleitung Nr 108166...
Страница 4: ...III bersicht Overview A D B C F E2 E1 K L M N O I G E2 J P U S Q H T R...
Страница 24: ...19...
Страница 41: ...36 Zeichnung Drawing...