6. Attach the clip that secures the power cord to the PSU.
Figure 25: Clip Closed
7. Connect the clip that secures the power cord to the PSU.
8.8
Installing the Power Cords
Personnel
Warnings
Required Tools
1
Disconnect all power sources
before servicing.
None
To install the Power Cords, do the following:
1. Run the cable through the CMA arm.
2. Connect the cable to the customer power source.
3. Connect the CMA arm to the ESM handle.
a) From the rear of the enclosure, slide the first CMA arm connector over the ESM on same side as the
arm.
b) To connect the arm to the enclosure, press down on the thumb release and push arm clip onto the ESM
handle.
Figure 26: Attaching the CMA Clip
c) On the CMA arm connector, slide the tab on the connector towards the ESM handle.
35
8
Installing the 4U60 G2 Storage Enclosure
Installation Guide
8.8
Installing the Power Cords
