UltraLine II VDSL– Draft 1
030-300237 Rev. A
8/8/06
030-300237 Rev. A
8
August 2006
User Guide
UltraLine II VDSL Gateway (Model 826010)
5.
HARDWARE FEATURES
5.1
LED Indicators
This section explains the LED states and descriptions of your Gateway. LED indicators can be used to verify the
Gateway’s operation and status.
LED States and Descriptions
LED State
Description
Solid Green
Gateway power is ON.
Solid Red
Gateway is in reset mode.
POWER
OFF
Gateway power is OFF.
Solid Green
Powered device is connected to the associated port (includes
devices with wake-on LAN capability where slight voltage is
supplied to an Ethernet connection).
Flashing Green
10/100 Base-T Ethernet LAN activity is present (LAN traffic in
either direction).
ETHERNET
(
LAN)
E1, E2, E3, E4
OFF
Gateway power is OFF, no cable or no powered device is
connected to the associated port.
Solid Green
Wireless is enabled and functioning.
Flashing Green
Wireless LAN activity present (traffic in either direction).
WIRELESS
Off
Wireless is disabled or not functioning.
Solid Green
Power on and synchronized with ISP’s VDSL equipment
Flashing Green
VDSL is attempting to sync.
Solid Amber
Gateway is in safe-boot mode.
Solid Red
VDSL line is failing to sync at the physical layer.
VDSL
Off
Power off, No VDSL signal detected.
Solid Green
Internet link established.
Flashing Green
IP connection established and IP Traffic is passing through
device (in either direction).
Note: If the IP or PPP session is dropped due to an idle timeout,
the light will remain solid green, if an ADSL connection is still
present.
If the session is dropped for any other reason, the light is turned
OFF. The light will turn red when it attempts to reconnect and
DHCP or PPP fails).
Solid Red
Device attempted to become IP connected and failed (no DHCP
response, no PPP response, PPP authentication failed, no IP
address from IPCP, etc.).
INTERNET
OFF
Gateway power is OFF, Gateway is in Bridge Mode, or the
connection is not present.
