Wenglor OPT2012, Руководство по эксплуатации

Страница: 24 / 25

24
EN
Designation Function
Lock Lock after Sensor
Password
 Enable
 Enter

Change
Lock
The sensor can be disabled with the help of this function, without interrupting
supply power.
The sensor is disabled and switched automatically to the password entry mode after
pressing the

key.
Enter
+
Enter

0
−
A password must be entered in order to continue using the sensor.
Notes regarding password functions:
If the password function has been activated, the password must be entered each time supply power to the
Sensor is interrupted.
After pressing a key, the menu is automatically switched to the password entry mode.
The following user interface then appears:
Password
+

−
Enter
0
After entering the correct password with the + or – key, the entire menu is enabled and the Sensor is ready for
use.
• The password function is deactivated upon shipment from the factory.
• Passwords can be selected within a range of 0000 to 9999.
Be sure to make a note of the new password before exiting the “change password” function! If the password
is forgotten, it must be overwritten with a master password. The master password can be requested by e-mail
from
techbox@automationdirect.com.
8. Maintenance Instructions
• This wenglor Sensor is maintenance-free.
• It is advisable to clean the lens and the display, and to check the plug connections at regular intervals.
• Do not clean with solvents or cleansers which could damage the device.
9. Proper Disposal
wenglor sensoric gmbh does not accept the return of unusable or irreparable products. Respectively valid
national waste disposal regulations apply to product disposal.