7
Installation (continued)
Floor Frame and Door Frame Assembly (continued)
5. Adjust the levelers on the underside of the door assembly so that when it is upright,
it will stand vertical, level and square to the floor.
Note:
Do not extend levelers beyond the gaskets attached to the underside of the
door frame assembly.
6. Attach a door connect bracket to the bottom outside edge on both sides of the door frame
assembly using two ¼-20 x ⅝" machine screws in each bracket as shown.
Note:
Do not over-tighten the machine screws
as this could cause the door connect brackets
to warp.
7. Stand the door frame assembly upright and use a box level to
check the level of the floor where the door frame assembly will be located.
Door
Connect
Bracket
¼-20 x ⅝"
Machine
Screws
Door
Connect
Bracket
¼-20 x ⅝"
Machine
Screws
Leveler
Leveler
The door frame assembly is
not self-supporting. It must be
supported until an adjacent wall
panel is attached.
!
CAUTION
