34
Maintenance
Cleaning
Painted Surfaces
— Any commercial non-abrasive cleaner.
Glass
— Any commercial glass cleaner.
Floor
— Standard floor cleaner.
Vent Grille
— Remove, clean in a commercial detergent and replace.
Perforated Surfaces
— Only slightly dampen a sponge or rag with water.
(Chemicals or excessive water can promote corrosion.
Door Hinge Lubrication
Lubricate the door hinge yearly with a PTFE (Teflon) based lubricant.
1. Open the door at least 90 degrees.
2. Place a rag or paper towel on the
floor under the hinge pin to collect
any excess lubricant.
3. From the inside of the door
frame, sparingly apply lubricant
at every hinge opening to both
the exposed hinge pin and
hinge barrel lifting cams.
4. Clean away excess lubricant
and remove the rag or
paper towel under the
hinge pin.
5. Close and open the door
several times to distribute
the lubricant.
Adjustments
Magnetic door gasket to door stop - Adjust only as necessary.
1. Loosen the screws in the vertical and/or horizontal door stops.
2. If the gap is too tight, tap stops away from door with a rubber mallet or smooth wooden block.
3. Close the door.
4. Gently tap stops toward magnetic gasket until a seal between magnet and door stop is made.
5. Open the door and re-tighten screws.
6. Remold sealant in upper corners where vertical and horizontal stops meet, if this seal is
damaged during adjustment.
7. If there is a gap between the door stop and gasket, see "Door Stop Adjustment".
Sweep Seal Gasket at bottom of the door - adjust only as necessary.
1. Loosen the two screws at the sweep on the latch side and one screw at the sweep on
the hinge side of the door.
2. Place a Phillips screwdriver bit on the screw heads and tap down on both ends of the seal
to the lower sweep seal.
Note:
If seal is forced down too far the door will be hard to open and close.
3. Tighten adjustment screws.
Lubricate
