Wen RT1460, Инструкция по эксплуатации

Страница: 7 / 24

7
ELECTRIC ROUTER SAFETY
1. The speed range of the router is 12,000 - 30,000 RPM.
Make sure that the router bit you wish to use is suitable
for your router. Check the router bit’s maximum speed
rating specified by the manufacturer. It must be capable
of operating at the maximum rotation speed of 30,000
RPM.
2. Never use dull or damaged router bits. Damaged bits
may break during use, and dull bits require additional
force to operate, which may cause you to lose control.
Any cracked or broken bit must be replaced before op-
eration.
3. Before installing a router bit, make sure the power
cord plug is removed from the electrical outlet and the
router is switched to off.
4. The router bit shank must fit the size of the collet. If
the router bit cannot be firmly gripped by the collet, it
will become loose during operation, resulting in serious
personal injury.
5. Never start the tool when the router bit is touching the
workpiece.
6. Make sure the collet nut and all adjustment knobs are
securely tightened before operating the router. Loose
adjustment knobs and collet nuts can cause unexpected
shifts in momentum, increasing the chances of personal
injury.
7. Always wear ANSI-approved safety goggles and hear-
ing protection when operating the router.
8. Before operating the router, be sure to run the ma-
chine without load for some time to check for runnout
due to improper installation of the router bit.
9. Avoid cutting nails and staples with the router. Before
operation, inspect the workpiece to make sure the work
surface is free from nails and other foreign objects. Cut-
ting into foreign objects can cause unexpected injury.
10. Always properly attach the workpiece to a stable
platform using clamps or other securing devices. Never
hold the workpiece in your hands or across your leg dur-
ing operation.
11. Hold the trim router straight base firmly with one
hand and the head of the router body with the other.
12. Keep in mind the rotational direction of the router bit
before attempting to operate. Always cut with the correct
direction of the feed in mind (see page 13, “Direction of
Feed”).
13. Do not set the router down until the motor has come
to a complete stop. The exposed spinning bit can cause
serious injury or cause the router to move unexpectedly.
14. Before removing the router bit from the workpiece,
make sure that the power switch is turned off and the
router bit has come to a complete stop.
15. To reduce the risk of getting burned, do not touch the
router bit immediately after use as it may get hot during
operation.
16. Always unplug the tool before changing bits or mak-
ing adjustments. Failure to do so can result in the tool
starting unexpectedly.
TRIM ROUTER SAFETY WARNINGS
WARNING! Do not operate the power tool until you have read and understood the following instructions and
the warning labels.