
1. Service indicator: The Service indicator may illuminate for 2 reasons. 1.) Water has triggered the leak
sensor. 2.) The filter life has reached its limit. NOTE: The filter indicator is optional and must be activated
by the dealer using the Dip Switches.
We strongly suggest NOT activating the optional Filter Life warning
because different usage may create unwanted service calls.
The filter life can be set by the dealer as
described int eh Dip Switch section. If the Service indicator is lit:
a. First check inside the lower front panel to ensure there are is no standing water on the leak
continuity sensor on the bottom plate.
i. If there is water, check for the source and dry the sensor and the Service light will turn off
b. Confirm Beep tone is turned on for the following step
c. The filters have reached their useful life as determined by your Dip Switch settings. To reset the
filter life aspect of the Service light:
i. Hold hand over HOT SELECT for 5 seconds until the Service indicator flashes
ii. Remove hand and then place hands over both the HOT SELECT and DISPENSE sensors for 5
seconds until a chime is heard
2. Flow Rate: The dispense Flow Rate on the Ascent 80 is set to 3 liters per minute (3 L/min). This is twice as
fast as a traditional cooler and is ideal for filling larger bottles. However, in certain settings the flow may be
too fast. An example is a waiting room that provides only small cups for the visitors. The Flow Rate can be
reduced to 2 liters per minute (2 L/min) using the following steps:
a. Confirm Beep tone is turned on
b. Hold both hands over HOT SELECT and DISPENSE sensors simultaneously for 5 seconds until the
audible Chime is heard
c. Remove hands and again place in front of HOT SELECT and DISPENSE sensors and hold for around 5
seconds until the audible Chime is heard
d. To reset the Flow Rate, repeat the above steps
In addition to the programming done with the Dip Switches, there are 3 items that can be changed using the
sensors as the programming tool: Service indicator, Flow Rate, and audible Beep tone.
NOTE: The Ascent 80 makes a Beep noise when a sensor is triggered. For programming, there is a second noise,
which we call a Chime. The Chime is an ascending tone of 3 to 6 notes. Do not assume the Beep is the Chime
1. Beep tone: The unit makes a Beep when a sensor is activated. This tone can be tuned off if the customer
desires silence. NOTE that when this tone is turned off, it will need to be turned on again for to hear the
Chimes referred to in the other following instructions. To turn off Beep tome:
a. Hold hand over HOT SELECT sensor for 1 second.
b. Then hold hand in front of DISPENSE sensor 5 times. The Beep should now be silenced
c. To restart the audible Beep, repeat above steps
19
Содержание W9CT
