Welch Allyn Spot Vital Signs 4400, Руководство по обслуживанию

Страница: 86 / 132

NOTE
You cannot initialize the board without setting up the
equipment for the Pressure Callibration test.
11. Observe the pressure calibration messages onscreen and follow the onscreen prompts to
manually adjust device pressure with the hand bulb to 250 ± 5 mmHg.
12. Once you reach the targeted pressure, enter the exact value on the pressure meter in the
Meter pressure field, then click
Next
to record this value.
If the test passes, a green check appears to the left of the test name. If the test fails, a red check
appears to the left of the test name, followed by a prompt to rerun the test.
13. Rerun the Pressure Calibration test as needed until the test passes.
14. If the second test passes, click
Close
.
The NIBP board is now initialized.
Configure the main PCA board
After installing a new PCA board, use the Welch Allyn Service Tool, Gold Edition, to prepare the
board for first-time use. This includes programming the device serial number into the new board
and initializing the NIBP board.
1. Log in to the Welch Allyn Service Tool, highlight your device in the Device list and click
Select
.
2. Select
Spot 4400
>
Configure
, and then click
Change
.
The
Change device configuration settings
dialog box appears.
3. Enter the device serial number.
The device serial number is located on the bottom of the device.
4. If the serial number of the main circuit board does not appear, enter it as the host controller
serial number.
The serial number is located on the circuit board.
5. Select the appropriate device model number from the drop-down list.
6. Click
Save
.
If you have not done so already, complete functional verification and calibration before using the
device.
82 Functional verification and calibration overview