Welch Allyn Scanteam 6180, Техническое руководство

Страница: 29 / 68

4–5
Programming the Scanner
The function of these commands is explained below.
DEFAULT
Scanning this symbol installs default values (indicated by *’s) at the active
programming level. For example, if the DEFAULT symbol is scanned
immediately following Page ENTER, it defaults the entire menu page. If it
is scanned following a major category selection like Codabar, it will default
that whole category. If DEFAULT is scanned following a subcategory
selection such as Code 128/Minimum Length, it will default just that
subcategory. Finally, if it is scanned immediately after scanning the WA
symbol, all of the wand Selections and Variables (on both menu pages) will
automatically default to those values indicated by the asterisk (*).
WA
As explained above, the WA symbol generates a global command. It is
intended to be used in conjunction with the DEFAULT symbol to reset all
wand decoder parameters to their default values. The sequence scan WA
followed by scan DEFAULT will cause all Selections and Variables on both
menu pages to reset to their default values.
EXIT
Scanning the EXIT symbol produces a command which can be used to
terminate programming on either menu page. The EXIT symbol must be
scanned before moving to or attempting to program on a different menu
page. When it is scanned, all configuration instructions for parameters
appearing on that page will be stored in memory.
ESCAPE
Scanning the ESCAPE symbol generates a command that will terminate a
programming sequence before it is completed and without saving the
configuration information. It can be used when a Selection and/or Variable
has been scanned in error. The programming sequence must then be
restarted.