Welch Allyn Kreativ Mach 5.0, Инструкция по эксплуатации

Страница: 26 / 37

Page 26 990008 Rev. H
7. Routine Maintenance
Proper maintenance of the Mach 5.0 and Mach 5.0 PLUS systems is necessary to
maintain a consistent cutting efficiency and top performance. Maintenance is limited to
general cleaning, inspecting internal components, pinch tube replacement, emptying
exhaust bottles, and keeping the powder chamber dry. The following are maintenance
procedures categorized by their required frequency.
Daily Requirements
Powder Chamber
•
Open the powder chamber. Observe the powder level and refill as necessary.
Remove and clean the white lid gasket thoroughly before replacing the lid.
Thoroughly clean all mating surfaces. Tighten the lid ring to avoid air leaks. Refer
to Chapter 5 for detailed instructions.
Exhaust bottle
•
The exhaust bottle should be emptied daily, and every time the powder chamber is
filled. It is important to make sure the internal filter is clean and tight. If the filter is
not tight, it should be removed and cleaned. Pay extra attention to cleaning all
threads and mating surfaces. Do not let the bottle overfill.
Weekly Requirements
Powder Chamber
• •
Inspect the powder chamber for moisture contamination. Look for powder clumps
or wet powder and replace as necessary. Refer to Chapter 5 for detailed
instructions.
Exhaust bottle
• •
Remove and clean the exhaust bottle filter. When replacing, make sure all threads
and mating surfaces are clean and tight.
Pinch tubes
• •
There are three pinch tubes inside three pinch valves located between the exhaust
bottle and the powder chamber. Remove the pinch tubes by removing two thumb
screws and the black cover block. Pull the tube from the hose assembly. Inspect
Chapter
7